Effect of Rolling-Remelting SIMA Process on Semi-Solid Microstructure of ZCuSn10 Alloy

E-ISSN： 1662-9779|2014|217|418-425

ISSN： 1012-0394

Source： Solid State Phenomena, Vol.2014, Iss.217, 2015-01, pp. : 418-425

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Deformation Behavior of Semi-Solid ZCuSn10P1 Copper Alloy during Isothermal Compression

Solid State Phenomena, Vol. 2016, Iss. 256, 2016-10 ,pp. : 31-38

Trans Tech Publications

Access to resources Recommend Favorite

Fabrication and microstructure evolution of semi-solid LY11 alloy by SIMA

By Jiang Haitao Li Xiaoli Xiong Aiming Li Miaoquan

Journal of Materials Engineering and Performance, Vol. 12, Iss. 3, 2003-06 ,pp. : 249-253

Springer Publishing Company

Access to resources Recommend Favorite

Effect of Hot Rolling and Equal-Channel Angular Pressing on Generation of Globular Microstructure in Semi-Solid Mg-3%Zn Alloy

Solid State Phenomena, Vol. 2014, Iss. 217, 2015-01 ,pp. : 381-388

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Chip Size on Semi-Solid Microstructure of AZ91D Magnesium Alloy Prepared by CRP Process

Solid State Phenomena, Vol. 2016, Iss. 256, 2016-10 ,pp. : 45-50

Trans Tech Publications

Access to resources Recommend Favorite

Experimental characterisation of a semi-solid A356 alloy during solidification and remelting

By Dziallach S. Benke S. Prahl U. Bleck W.

International Journal of Cast Metals Research, Vol. 22, Iss. 1-4, 2009-08 ,pp. : 248-251

Maney Publishing

Access to resources Recommend Favorite