Influence of the Materials Combination for the Surface Temperature of the Bimetallic Wire Deformed in the Cold Drawing Process

Publisher： Trans Tech Publications

E-ISSN： 1662-9779|2015|226|53-58

ISSN： 1012-0394

Source： Solid State Phenomena, Vol.2015, Iss.226, 2015-02, pp. : 53-7

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

The Influence of the Components of the Bimetallic Tubes for the Way of Deforming in the Hollow Drawing Process

By  

Solid State Phenomena, Vol. 2016, Iss. 246, 2016-03 ,pp. : 225-230

Trans Tech Publications

Access to resources Recommend Favorite

Research of the Laboratory Wire Drawing Process of Zinc

By  

Key Engineering Materials, Vol. 2016, Iss. 682, 2016-03 ,pp. : 367-371

Trans Tech Publications

Access to resources Recommend Favorite

The Influence the Temperature of Drawing Process on the Transformation Retained Austenite into Martensite for TRIP Steel Wires

By  

Solid State Phenomena, Vol. 2015, Iss. 220, 2015-01 ,pp. : 661-7

Trans Tech Publications

Access to resources Recommend Favorite

Study on Wire Rod Drawing Process Using the Rotating Die

By  

Key Engineering Materials, Vol. 2016, Iss. 716, 2016-11 ,pp. : 63-67

Trans Tech Publications

Access to resources Recommend Favorite

Determination of Frictional Forces during Wire Rod Drawing Process by Reverse Method

By  

Solid State Phenomena, Vol. 2017, Iss. 265, 2017-10 ,pp. : 1152-1156

Trans Tech Publications

Access to resources Recommend Favorite