A Novel Compound Machining of AISI 321 Stainless Steel Using Small Diameter Electrodes

E-ISSN： 1662-7482|2014|716|36-40

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2014, Iss.716, 2015-02, pp. : 36-40

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Experimental Investigation of Machining Parameters during Turning of AISI 316L Stainless Steel Using Nano Cutting Environment

Applied Mechanics and Materials, Vol. 2015, Iss. 787, 2015-09 ,pp. : 361-365

Trans Tech Publications

Access to resources Recommend Favorite

Improved Surface Integrity during End Milling AISI 316L Stainless Steel Using Heat Assisted Machining

Applied Mechanics and Materials, Vol. 2015, Iss. 752, 2015-05 ,pp. : 62-67

Trans Tech Publications

Access to resources Recommend Favorite

FEM Simulation of Machining AISI 1045 Steel Using Driven Rotary Tool

Applied Mechanics and Materials, Vol. 2015, Iss. 758, 2015-05 ,pp. : 77-82

Trans Tech Publications

Access to resources Recommend Favorite

Experimental Analysis of Machining Parameters in WEDM of AISI D3 Steel Using Taguchi Method

Applied Mechanics and Materials, Vol. 2015, Iss. 799, 2015-11 ,pp. : 343-350

Trans Tech Publications

Access to resources Recommend Favorite

On-Line Monitoring of Drill Wear in Machining of AISI 1040 Steel Using Virtual Instrumentation

Applied Mechanics and Materials, Vol. 2016, Iss. 852, 2016-10 ,pp. : 205-211

Trans Tech Publications

Access to resources Recommend Favorite