Development of EDM Equipment for Machining Film Cooling Holes

Publisher： Trans Tech Publications

E-ISSN： 1662-7482|2014|722|285-290

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2014, Iss.722, 2015-03, pp. : 285-290

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

The Use of Compound Cooling Holes for Film Cooling at the End Wall of Combustor Simulator

By  

Applied Mechanics and Materials, Vol. 2014, Iss. 695, 2015-01 ,pp. : 371-375

Trans Tech Publications

Access to resources Recommend Favorite

Experimental Study on Film Cooling Effectiveness of Shallow Hole with Upstream Sister Holes

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 773, 2015-08 ,pp. : 393-397

Trans Tech Publications

Access to resources Recommend Favorite

Comparative Analysis of Flow Field in Mixed and Non Mixed Gas Electrochemical Machining for Aero-Engine Turbine Blade Cooling Holes

By  

Applied Mechanics and Materials, Vol. 2017, Iss. 868, 2017-08 ,pp. : 166-171

Trans Tech Publications

Access to resources Recommend Favorite

Analyzes of Film Cooling Effectiveness from Cylindrical and Staggered Compound Cooling Holes with Alignment Angle of 30 Degree at the End of Combustor

By  

Applied Mechanics and Materials, Vol. 2014, Iss. 695, 2015-01 ,pp. : 389-392

Trans Tech Publications

Access to resources Recommend Favorite

Analyzes of Film Cooling from Cylindrical and Row Trenched Holes with Alignment Angle of 90 Degrees at Low Blowing Ratio

By  

Applied Mechanics and Materials, Vol. 2014, Iss. 695, 2015-01 ,pp. : 376-379

Trans Tech Publications

Access to resources Recommend Favorite