Design of Automatically Picking-Up Table Tennis Based on OpenCV

E-ISSN： 1662-7482|2015|734|157-160

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2015, Iss.734, 2015-04, pp. : 157-160

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Design of Intelligent Wagon which Can Automatically Enter into Garage Based on STC89C52

Applied Mechanics and Materials, Vol. 2015, Iss. 713, 2015-02 ,pp. : 987-991

Trans Tech Publications

Access to resources Recommend Favorite

Comparison of Wind Load Analysis Results Based on Indonesia Minimum Design Loads Standard SNI 1727:2013 Inputted Automatically and Manually by Using SAP2000

Applied Mechanics and Materials, Vol. 2018, Iss. 881, 2018-07 ,pp. : 132-141

Trans Tech Publications

Access to resources Recommend Favorite

The Research of Order Picking Optimization Based on Jointown Pharmaceutical Logistics Center

Applied Mechanics and Materials, Vol. 2014, Iss. 701, 2015-01 ,pp. : 94-97

Trans Tech Publications

Access to resources Recommend Favorite

Parametric Design of Deep Groove Ball Bearing Based on Pro/Program and Family Table

Applied Mechanics and Materials, Vol. 2014, Iss. 721, 2015-02 ,pp. : 113-117

Trans Tech Publications

Access to resources Recommend Favorite

Design of Flow Adjusting Device in Diffuser of Open-Circuit Wind Tunnel with Low Speed Based on CFX

Applied Mechanics and Materials, Vol. 2015, Iss. 799, 2015-11 ,pp. : 640-644

Trans Tech Publications

Access to resources Recommend Favorite