Drawing and Forming Parameters of Tailor-Welded Plates of High Strength Steel in Nonuniform Thickness

E-ISSN： 1662-7482|2015|750|382-388

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2015, Iss.750, 2015-05, pp. : 382-388

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Effect of Forming Parameters on Springback of Advanced High Strength Steel DP800

Applied Mechanics and Materials, Vol. 2014, Iss. 703, 2015-01 ,pp. : 182-186

Trans Tech Publications

Access to resources Recommend Favorite

Applying 2^k Factorial Design to Study on Parameters Affecting Springback of Forming of Advanced High Strength Steel Sheets (AHSS)

Applied Mechanics and Materials, Vol. 2017, Iss. 872, 2017-11 ,pp. : 83-88

Trans Tech Publications

Access to resources Recommend Favorite

The Optimization Method of Tailor Welded Blank Forming Process Based on Numerical Simulation

Applied Mechanics and Materials, Vol. 2014, Iss. 721, 2015-02 ,pp. : 135-139

Trans Tech Publications

Access to resources Recommend Favorite

Ultimate strength of dented steel plates under axial compressive loads

By Paik J.K. Lee J.M. Lee D.H.

International Journal of Mechanical Sciences, Vol. 45, Iss. 3, 2003-03 ,pp. : 433-448

Elsevier

Access to resources Recommend Favorite

A Study on the Microstructure of Welded Structural Steel Members at High Temperature

Applied Mechanics and Materials, Vol. 2015, Iss. 784, 2015-09 ,pp. : 397-402

Trans Tech Publications

Access to resources Recommend Favorite