Influence of Chip Formation Characteristics on Flank Contact Load Distribution in Titanium Alloy Cutting

E-ISSN： 1662-7482|2015|756|126-131

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2015, Iss.756, 2015-05, pp. : 126-131

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Experimental Investigation and Finite Element Analysis of Milling of Ti-6Al-4V Titanium Alloy by Studying Cutting Forces and Chip Microstructure

Applied Mechanics and Materials, Vol. 2016, Iss. 852, 2016-10 ,pp. : 311-316

Trans Tech Publications

Access to resources Recommend Favorite

EFFECT OF CUTTING CONDITIONS ON THE SERRATED CHIP FORMATION IN HIGH-SPEED CUTTING

By Gao Chongyang

Machining Science and Technology, Vol. 17, Iss. 1, 2013-01 ,pp. : 26-40

Taylor & Francis Ltd

Access to resources Recommend Favorite

Particle Finite Element Simulation of Chip Formation in Cutting Processes

Applied Mechanics and Materials, Vol. 2017, Iss. 869, 2017-09 ,pp. : 50-61

Trans Tech Publications

Access to resources Recommend Favorite

Formation of Nano-Sized Structural-Phase States in Surface Layers of a Cermet Alloy and the Influence of the States on the Tool Life of Cermet Plates in Metal Cutting

Applied Mechanics and Materials, Vol. 2015, Iss. 770, 2015-07 ,pp. : 144-150

Trans Tech Publications

Access to resources Recommend Favorite

Study on the Cutting Temperature and Chips Formation during the Milling of Pure Titanium

Applied Mechanics and Materials, Vol. 2018, Iss. 880, 2018-05 ,pp. : 315-320

Trans Tech Publications

Access to resources Recommend Favorite