Effect Pouring Temperature on Casting Defect Susceptibility of Hot Tearing in Metal Alloy Al-Si

E-ISSN： 1662-7482|2015|758|95-99

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2015, Iss.758, 2015-05, pp. : 95-99

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Influence of Cooling Rate on Fatigue Behaviour of Eutectic Al-Si (A413) Alloy Casting

Applied Mechanics and Materials, Vol. 2015, Iss. 787, 2015-09 ,pp. : 490-494

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Pouring Temperature and Cooling Slope Length on Microstructure and Mechanical Properties of Rheocast A319 Aluminium Alloy

Applied Mechanics and Materials, Vol. 2014, Iss. 699, 2015-01 ,pp. : 251-256

Trans Tech Publications

Access to resources Recommend Favorite

Tribological Behaviour of SiC Particle Reinforced Al-Si Alloy

By Kaur Kamalpreet

Tribology Letters, Vol. 44, Iss. 1, 2011-10 ,pp. : 41-58

Springer Publishing Company

Access to resources Recommend Favorite

Effect of Particle Size on Tribological Behavior of Rice Husk Ash–Reinforced Aluminum Alloy (AlSi10Mg) Matrix Composites

By Saravanan S. D. Senthilkumar M. Shankar S.

Tribology Transactions, Vol. 56, Iss. 6, 2013-11 ,pp. : 1156-1167

Taylor & Francis Ltd

Access to resources Recommend Favorite

Dry Sliding Wear Behavior of Zircon Sand Reinforced Al–Si Alloy

By Kaur Kamalpreet

Tribology Letters, Vol. 38, Iss. 3, 2010-06 ,pp. : 377-387

Springer Publishing Company

Access to resources Recommend Favorite