Analysis of Micropattern Fabrication for Micromold Using Low Power CO₂ Laser

E-ISSN： 1662-7482|2015|758|51-56

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2015, Iss.758, 2015-05, pp. : 51-56

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Obtaining Holes in Plexiglas Using Low Power CO₂ Laser Beam

Applied Mechanics and Materials, Vol. 2015, Iss. 760, 2015-06 ,pp. : 563-568

Trans Tech Publications

Access to resources Recommend Favorite

Elimination of Clogging in PMMA Microchannels Using Water Assisted CO₂ Laser Micromachining

Applied Mechanics and Materials, Vol. 2015, Iss. 799, 2015-11 ,pp. : 407-412

Trans Tech Publications

Access to resources Recommend Favorite

An Analysis of Simulation System of CO₂ Emission and Emission Reduction Paths in Chongqing’s Electric Power Industry

Applied Mechanics and Materials, Vol. 2014, Iss. 700, 2015-01 ,pp. : 431-436

Trans Tech Publications

Access to resources Recommend Favorite

Stratified Flow Condensation of CO₂ in a Tube at Low Temperatures

Applied Mechanics and Materials, Vol. 2015, Iss. 789, 2015-10 ,pp. : 184-192

Trans Tech Publications

Access to resources Recommend Favorite

A Study on the Numerical Analysis of Main Valve for Emergency Escape Using Marine Craft CO₂ System

Applied Mechanics and Materials, Vol. 2015, Iss. 727, 2015-03 ,pp. : 572-577

Trans Tech Publications

Access to resources Recommend Favorite