Performance Study on Copper Coated Tool Using Powder Mixed EDM of Monel 400

Publisher： Trans Tech Publications

E-ISSN： 1662-7482|2015|766|600-605

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2015, Iss.766, 2015-07, pp. : 600-605

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Performance and Analysis of Silicon Mixed Kerosene Servotherm in EDM of Monel 400

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 766, 2015-07 ,pp. : 674-680

Trans Tech Publications

Access to resources Recommend Favorite

An Investigation of the Influences of EDM Parameters and Tool Geometries on Radial Overcut for Monel 400 Material with Tungsten Copper Electrode

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 766, 2015-07 ,pp. : 908-913

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Powder Concentration in EDM Process with Powder-Mixed Dielectric (PMD-EDM)

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 813, 2015-12 ,pp. : 304-308

Trans Tech Publications

Access to resources Recommend Favorite

Effects of Electrical Process Parameters and Electrode Tool Geometries in EDM of Inconel825 Material Using Zirconium Copper Electrode

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 766, 2015-07 ,pp. : 668-673

Trans Tech Publications

Access to resources Recommend Favorite

Machinability Study of Beryllium Copper by Powder Mixed Electric Discharge Machining

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 787, 2015-09 ,pp. : 376-380

Trans Tech Publications

Access to resources Recommend Favorite