Basic Conditions for 5-Axis Milling of Impeller Specific Surfaces

E-ISSN： 1662-7482|2015|760|367-372

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2015, Iss.760, 2015-06, pp. : 367-372

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

MODELING OF 5-AXIS MILLING PROCESSES

By Ozturk E. Budak E.

Machining Science and Technology, Vol. 11, Iss. 3, 2007-07 ,pp. : 287-311

Taylor & Francis Ltd

Access to resources Recommend Favorite

Research on 5 Axis Tool-Path Based on Constant Shearing Stress for Milling Thin-Wall Ceramics

Applied Mechanics and Materials, Vol. 2015, Iss. 778, 2015-08 ,pp. : 152-158

Trans Tech Publications

Access to resources Recommend Favorite

Machining Simulation for Centrifugal Impeller Based on Modelling of Five-Axis Machining Center

Applied Mechanics and Materials, Vol. 2015, Iss. 741, 2015-04 ,pp. : 227-231

Trans Tech Publications

Access to resources Recommend Favorite

SIMULATION CONCEPT FOR PREDICTING WORKPIECE VIBRATIONS IN FIVE-AXIS MILLING

By Kersting P. Biermann D.

Machining Science and Technology, Vol. 13, Iss. 2, 2009-04 ,pp. : 196-209

Taylor & Francis Ltd

Access to resources Recommend Favorite

Development of Three-Axis Mini Milling Machine for Small Scale Production

Applied Mechanics and Materials, Vol. 2015, Iss. 761, 2015-06 ,pp. : 273-276

Trans Tech Publications

Access to resources Recommend Favorite