Experimental Research on Surface Roughness in Turning of E355 Alloy Steel on CNC Machine Tool

E-ISSN： 1662-7482|2015|760|385-390

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2015, Iss.760, 2015-06, pp. : 385-390

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Grey Relational Technique Used to Optimise the Cutting Conditions for Surface Roughness and Tool Wear in CNC Turning

International Journal of Mechanical Engineering and Automation, Vol. 2, Iss. 11, 2015-11 ,pp. : 483-490

Ethan Publishing Company

Access to resources Recommend Favorite

Optimization of MRR and Surface Roughness of AlMg3 (AA5754) Alloy in CNC Lathe Machine by Using Taguchi Method

Applied Mechanics and Materials, Vol. 2018, Iss. 877, 2018-03 ,pp. : 110-117

Trans Tech Publications

Access to resources Recommend Favorite

Development of a Passive Damping Tool Holder for the Improvement of Surace Roughness in Turning Operation of Stainless Steel

Applied Mechanics and Materials, Vol. 2016, Iss. 860, 2017-02 ,pp. : 70-73

Trans Tech Publications

Access to resources Recommend Favorite

Analysis of Cutting Parameters Influence on the Machined Surface Roughness Obtained by Turning of a Heat Treated Bearing Steel

Applied Mechanics and Materials, Vol. 2015, Iss. 809, 2015-12 ,pp. : 195-200

Trans Tech Publications

Access to resources Recommend Favorite

Surface Roughness Prediction During Dry Turning of Austenitic Stainless Steel AISI 304

Applied Mechanics and Materials, Vol. 2015, Iss. 808, 2015-12 ,pp. : 54-59

Trans Tech Publications

Access to resources Recommend Favorite