Compression Molding Cure Cycle Modelling and Optimization for Large Polymeric Composite Parts Processing

E-ISSN： 1662-7482|2015|772|257-262

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2015, Iss.772, 2015-08, pp. : 257-262

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Sheet Moulding Compounds of Large Auto Body Parts Made from Polymeric Composite

Applied Mechanics and Materials, Vol. 2015, Iss. 760, 2015-06 ,pp. : 501-506

Trans Tech Publications

Access to resources Recommend Favorite

Influence of Processing Parameters in Reaction Injection Foam Molding for Multi-Layer Parts on Foam Structure and Mechanical Properties

Applied Mechanics and Materials, Vol. 2015, Iss. 805, 2015-12 ,pp. : 131-138

Trans Tech Publications

Access to resources Recommend Favorite

Optimization of the Drill Angle of Attack in Composite Processing

Applied Mechanics and Materials, Vol. 2015, Iss. 760, 2015-06 ,pp. : 489-494

Trans Tech Publications

Access to resources Recommend Favorite

Research on Fracture Mechanics and Dispersed Structure of the Polymeric Composite Materials under Abrasive Processing

Applied Mechanics and Materials, Vol. 2015, Iss. 756, 2015-05 ,pp. : 19-23

Trans Tech Publications

Access to resources Recommend Favorite

Optimization of Products Life Cycle

Applied Mechanics and Materials, Vol. 2015, Iss. 770, 2015-07 ,pp. : 662-669

Trans Tech Publications

Access to resources Recommend Favorite