Optimization of Cutter Geometry Features to Minimise Cutting Force on Machining Polyetheretherketone (PEEK) Engineering Plastic

Publisher： Trans Tech Publications

E-ISSN： 1662-7482|2015|761|282-286

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2015, Iss.761, 2015-06, pp. : 282-286

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Determination on the Effect of Cutter Geometrical Feature for Machining Polyetheretherketone (PEEK) Using Taguchi Methods

By  

Applied Mechanics and Materials, Vol. 2014, Iss. 699, 2015-01 ,pp. : 192-197

Trans Tech Publications

Access to resources Recommend Favorite

Optimization of Cutting Parameters in Machining GFRP Using End Mill Cutter through DoE and Verification through Genetic Algorithm

By  

Applied Mechanics and Materials, Vol. 2017, Iss. 867, 2017-08 ,pp. : 134-147

Trans Tech Publications

Access to resources Recommend Favorite

A Parametric Optimization on Cutting Force during Laser Assisted Machining of Inconel 718 Alloy

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 787, 2015-09 ,pp. : 460-464

Trans Tech Publications

Access to resources Recommend Favorite

Optimization of Dry Sliding Wear Parameters of MWCNT Reinforced Poly-Ether-Ether-Ketone (PEEK) Composites

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 813, 2015-12 ,pp. : 218-225

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Cutting Parameters on Feed Force in Machining AISI 1018 Steel

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 813, 2015-12 ,pp. : 299-303

Trans Tech Publications

Access to resources Recommend Favorite