An automation of design and modelling tasks in NX Siemens environment with original software - generator module

E-ISSN： 1757-899X|95|1|715-720

ISSN： 1757-899X

Source： IOP Conference Series: Materials Science and Engineering, Vol.95, Iss.1, 2015-11, pp. : 715-720

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

An automation of design and modelling tasks in NX Siemens environment with original software - cost module

IOP Conference Series: Materials Science and Engineering, Vol. 95, Iss. 1, 2015-11 ,pp. : 721-726

IOP Publishing

Access to resources Recommend Favorite

A method of computer aided design with self-generative models in NX Siemens environment

IOP Conference Series: Materials Science and Engineering, Vol. 95, Iss. 1, 2015-11 ,pp. : 751-756

IOP Publishing

Access to resources Recommend Favorite

Strength analysis of parallel robot components in PLM Siemens NX 8.5 program

IOP Conference Series: Materials Science and Engineering, Vol. 95, Iss. 1, 2015-11 ,pp. : 620-625

IOP Publishing

Access to resources Recommend Favorite

Designing Forging and Die Tooling for the Manufacture of Turbine Engine Compressor Blades in Siemens NX

Key Engineering Materials, Vol. 2016, Iss. 684, 2016-03 ,pp. : 497-506

Trans Tech Publications

Access to resources Recommend Favorite

Rotating cylinder design as a lifting generator

IOP Conference Series: Materials Science and Engineering, Vol. 50, Iss. 1, 2013-12 ,pp. : 181-190

IOP Publishing

Access to resources Recommend Favorite