Spring-back of flexible roll forming bending process

Publisher： IOP Publishing

E-ISSN： 1757-899X|103|1|200-205

ISSN： 1757-899X

Source： IOP Conference Series: Materials Science and Engineering, Vol.103, Iss.1, 2015-12, pp. : 200-205

Access to resources Favorite

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Study on springback of high tension steel following various temperature and local pre-heating in the roll forming process

By  

IOP Conference Series: Materials Science and Engineering, Vol. 103, Iss. 1, 2015-12 ,pp. : 248-258

IOP Publishing

Access to resources Recommend Favorite

Stability of a Suppression Method of Dent and Spring-Back in Zigzag Bending of Sheet Metal/Plate

By  

Key Engineering Materials, Vol. 2016, Iss. 716, 2016-11 ,pp. : 931-940

Trans Tech Publications

Access to resources Recommend Favorite

Minimizing the edge buckling of the cold roll-forming process

By  

IOP Conference Series: Materials Science and Engineering, Vol. 10, Iss. 1, 2010-06 ,pp. : 1348-1357

IOP Publishing

Access to resources Recommend Favorite

The Roll-Forming Process Analysis of the Situation and Development Trend

By  

Key Engineering Materials, Vol. 2018, Iss. 764, 2018-03 ,pp. : 201-209

Trans Tech Publications

Access to resources Recommend Favorite

Investigation on Variation of Bow Defect in Roll Forming Process

By  

Key Engineering Materials, Vol. 2017, Iss. 729, 2017-03 ,pp. : 80-85

Trans Tech Publications

Access to resources Recommend Favorite