Influence of Various Cutting Fluids on Energy Consumption during Turning

E-ISSN： 1662-9795|2016|686|252-256

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2016, Iss.686, 2016-03, pp. : 252-256

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Difference of Feed Marks in Cutting Fluids when Turning Stainless Steel

Key Engineering Materials, Vol. 2017, Iss. 749, 2017-09 ,pp. : 111-117

Trans Tech Publications

Access to resources Recommend Favorite

Effects of Cutting Speed, Cutting Fluid, and Carbon Fiber Orientation on Cutting of CFRP during Turning

Key Engineering Materials, Vol. 2017, Iss. 740, 2017-07 ,pp. : 133-138

Trans Tech Publications

Access to resources Recommend Favorite

Estimation of Local Plastic Deformation in Cutting Zone during Turning

Key Engineering Materials, Vol. 2015, Iss. 662, 2015-10 ,pp. : 173-176

Trans Tech Publications

Access to resources Recommend Favorite

Influence of Cutting Fluid Conditions and Cutting Parameters on the Chip Form in Turning of Titanium and Steel Alloys

Key Engineering Materials, Vol. 2016, Iss. 686, 2016-03 ,pp. : 74-79

Trans Tech Publications

Access to resources Recommend Favorite

The damage of the cutting tools out of carbide metallic during the turning of a soaked and not hardened steel XC38

IOP Conference Series: Materials Science and Engineering, Vol. 28, Iss. 1, 2012-02 ,pp. : 211-220

IOP Publishing

Access to resources Recommend Favorite