Morphology of the Chip Formation at Orthogonal High Speed Milling of AISI H13

E-ISSN： 1662-9795|2016|686|45-50

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2016, Iss.686, 2016-03, pp. : 45-50

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Cutting Force in High-Speed Face Milling AISI H13 Steel

Key Engineering Materials, Vol. 2015, Iss. 667, 2016-02 ,pp. : 35-40

Trans Tech Publications

Access to resources Recommend Favorite

A note on the problem of shear localization during chip formation in orthogonal machining

By Huang J Aifantis E.C

Journal of Materials Engineering and Performance, Vol. 6, Iss. 1, 1997-02 ,pp. : 25-26

Springer Publishing Company

Access to resources Recommend Favorite

Roughness profile in high speed face milling operation

By Louati H. Bouzid W.

Materials Technology: Advanced Performance Materials, Vol. 23, Iss. 4, 2008-12 ,pp. : 231-237

Maney Publishing

Access to resources Recommend Favorite

An investigation of cutting mechanics in 2 dimensional ultrasonic vibration assisted milling toward chip thickness and chip formation

IOP Conference Series: Materials Science and Engineering, Vol. 100, Iss. 1, 2015-12 ,pp. : 468-473

IOP Publishing

Access to resources Recommend Favorite

The Influence of High Energy Ball Milling on the Morphology of Metal-Ceramic Composite Powders

Solid State Phenomena, Vol. 2016, Iss. 246, 2016-03 ,pp. : 59-62

Trans Tech Publications

Access to resources Recommend Favorite