Cutting Force during Grinding Determined by Regression Analysis and Genetic Algorithms

Publisher： Trans Tech Publications

E-ISSN： 1662-9795|2016|686|13-18

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2016, Iss.686, 2016-03, pp. : 13-18

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Influence of Grinding Wheel Dressing on the Roughness of Final Surface and Cutting Force during GGG60 Grinding

By  

Key Engineering Materials, Vol. 2016, Iss. 686, 2016-03 ,pp. : 218-223

Trans Tech Publications

Access to resources Recommend Favorite

The Influence of Cutting Conditions on Surface Roughness during Steel 100Cr6 Grinding

By  

Solid State Phenomena, Vol. 2017, Iss. 261, 2017-09 ,pp. : 215-220

Trans Tech Publications

Access to resources Recommend Favorite

Cutting capacity and strength of single grinding grains

By  

IOP Conference Series: Materials Science and Engineering, Vol. 91, Iss. 1, 2015-09 ,pp. : 329-335

IOP Publishing

Access to resources Recommend Favorite

Application of Taguchi Method to Optimization of Cutting Force and Temperature during Turning of Difficult to Cut Materials

By  

Key Engineering Materials, Vol. 2016, Iss. 686, 2016-03 ,pp. : 114-118

Trans Tech Publications

Access to resources Recommend Favorite

The X-C Linkage Grinding Force Model in Cam Grinding

By  

Key Engineering Materials, Vol. 2016, Iss. 693, 2016-06 ,pp. : 1187-1194

Trans Tech Publications

Access to resources Recommend Favorite