Identification of the Minimal Thickness of Cutting Layer Based on the Acoustic Emission Signal

E-ISSN： 1662-9795|2016|686|39-44

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2016, Iss.686, 2016-03, pp. : 39-44

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

A Method for Determination of the Minimal Thickness of the Cutting Layer during Precision Machining Performed with the Indexable Cutting Tools

Solid State Phenomena, Vol. 2017, Iss. 261, 2017-09 ,pp. : 50-57

Trans Tech Publications

Access to resources Recommend Favorite

An acoustic emission study of cutting bauxite refractory ceramics by abrasive water jets

By Momber A. Mohan R. Kovacevic R.

Journal of Materials Engineering and Performance, Vol. 8, Iss. 4, 1999-08 ,pp. : 450-454

Springer Publishing Company

Access to resources Recommend Favorite

Study of Electroplated Nickel Layer Thickness and Saw Parameters on Cutting Performance in Diamond Wire Sawing of Sapphire Ingots

Key Engineering Materials, Vol. 2015, Iss. 656, 2015-08 ,pp. : 450-455

Trans Tech Publications

Access to resources Recommend Favorite

Evaluating Tensile Properties of Wool Fibers Based on the Waveform of Acoustic Emission

Key Engineering Materials, Vol. 2015, Iss. 671, 2016-02 ,pp. : 391-396

Trans Tech Publications

Access to resources Recommend Favorite

An Intelligent Grinding Wheel Wear Monitoring System Based on Acoustic Emission

Solid State Phenomena, Vol. 2017, Iss. 261, 2017-09 ,pp. : 195-200

Trans Tech Publications

Access to resources Recommend Favorite