Combined Isothermal Drawing of Axissymmetrical Parts Made out of Anisotropic Materials in Mode of Short-Time Creeping

E-ISSN： 1662-9795|2016|684|152-164

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2016, Iss.684, 2016-03, pp. : 152-164

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Isothermal Backward Extrusion of Thick-Walled Anisotropic Pipe Blanks in Mode of Short-Time Creeping

Key Engineering Materials, Vol. 2016, Iss. 684, 2016-03 ,pp. : 143-151

Trans Tech Publications

Access to resources Recommend Favorite

Technological Modes of Stretching Operation Involving Wall Thinning of Axissymmetric Blanks Made out of Anisotropic Materials

Key Engineering Materials, Vol. 2016, Iss. 684, 2016-03 ,pp. : 165-174

Trans Tech Publications

Access to resources Recommend Favorite

Short-Time Induction Sintering of Hardmetals

By Hermel W. Förster W. Krumphold R. Leitner G. Voigt K.

Powder Metallurgy, Vol. 26, Iss. 4, 1983-01 ,pp. : 217-220

Maney Publishing

Access to resources Recommend Favorite

Failure prevention by short-time corrosion tests

By Mickalonis J.

Journal of Failure Analysis & Prevention, Vol. 5, Iss. 4, 2005-08 ,pp. : 46-53

Springer Publishing Company

Access to resources Recommend Favorite

Comparison of Experimental Stamping Punch Machinability Made out of Unconventional Materials

Key Engineering Materials, Vol. 2014, Iss. 635, 2015-02 ,pp. : 81-84

Trans Tech Publications

Access to resources Recommend Favorite