Influence of Surface Conditions on the Fatigue Behavior of A357 Aluminum Alloy

E-ISSN： 1662-9752|2016|850|113-119

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2016, Iss.850, 2016-04, pp. : 113-119

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Influence of surface topography on the frictional characteristics of 3104 aluminum alloy sheet

By Saha P.K. Wilson W.R.D. Timsit R.S.

Wear, Vol. 197, Iss. 1, 1996-09 ,pp. : 123-129

Elsevier

Access to resources Recommend Favorite

Investigation on Mode I Propagation Behavior of Fatigue Crack in Precipitation-Hardened Aluminum Alloy with Different Mg Content

Materials Science Forum, Vol. 2017, Iss. 889, 2017-04 ,pp. : 143-147

Trans Tech Publications

Access to resources Recommend Favorite

Stress corrosion cracking and corrosion fatigue cracking behavior of A7N01P‐T4 aluminum alloy

MATERIALS AND CORROSION/WERKSTOFFE UND KORROSION, Vol. 69, Iss. 2, 2018-02 ,pp. : 207-214

John Wiley & Sons Inc

Access to resources Recommend Favorite

Finite Element Analysis of the Influence of Crack Tip Stress Distributionon Fatigue Crack Propagation Rate of 5XXX Aluminum Alloy

Materials Science Forum, Vol. 2015, Iss. 817, 2015-05 ,pp. : 698-705

Trans Tech Publications

Access to resources Recommend Favorite

Behavior of alloy Ti-6Al-4V under pre-fretting and subsequent fatigue conditions

By Glaeser W.A. Lawless B.H.

Wear, Vol. 250, Iss. 1, 2001-10 ,pp. : 621-630

Elsevier

Access to resources Recommend Favorite