The Effect of Sheet Thickness, Loading Rate and Punch Diameter on the Deformation Behaviour of AZ31 during 3-Point Bending

Publisher： Trans Tech Publications

E-ISSN： 1662-9752|2016|854|65-72

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2016, Iss.854, 2016-06, pp. : 65-72

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Effect of Deformation Homogeneity on Grain Refinement of AZ31 Magnesium Alloys Based on FEA during ECAP

By  

Materials Science Forum, Vol. 2016, Iss. 850, 2016-04 ,pp. : 281-286

Trans Tech Publications

Access to resources Recommend Favorite

Bending Collapse Behaviour of Polyurethane Foam-Filled Rectangular Magnesium Alloy AZ31B Tubes

By  

Materials Science Forum, Vol. 2015, Iss. 828, 2015-09 ,pp. : 259-264

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Additional Shear Stress on Microstructure Evolution of AZ31 Sheet by Differential Speed Rolling

By  

Materials Science Forum, Vol. 2015, Iss. 816, 2015-05 ,pp. : 433-438

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Large Strain on Texture Formation Behavior of AZ80 Magnesium Alloy during High Temperature Deformation

By  

Materials Science Forum, Vol. 2016, Iss. 879, 2017-02 ,pp. : 938-942

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Annealing on Hardness Penetration of Caliber Rolled Mg-3Al-1Zn (AZ31) Alloy

By  

Materials Science Forum, Vol. 2015, Iss. 830, 2015-10 ,pp. : 177-180

Trans Tech Publications

Access to resources Recommend Favorite