Microstructural Evolution of Body-Centred Cubic Fe-Al Alloy by Friction Stir Processing with SiC Particles Addition

E-ISSN： 1662-9752|2016|838|326-331

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2016, Iss.838, 2016-02, pp. : 326-331

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Microstructural Modification of Non-Combustible Magnesium Alloy by Friction Stir Processing

Materials Science Forum, Vol. 2016, Iss. 880, 2017-02 ,pp. : 25-28

Trans Tech Publications

Access to resources Recommend Favorite

Processing Map and Microstructural Evolution of Isothermal Compressed an Al-Mg-Si-Cu-Zn Alloy

Materials Science Forum, Vol. 2016, Iss. 877, 2017-01 ,pp. : 575-580

Trans Tech Publications

Access to resources Recommend Favorite

Microstructural Modification of AZ91 Magnesium Alloy Using Friction Stir Processing and Carbon Fibers

Materials Science Forum, Vol. 2017, Iss. 886, 2017-04 ,pp. : 55-58

Trans Tech Publications

Access to resources Recommend Favorite

The sliding wear resistance behavior of NiAl and SiC particles reinforced aluminum alloy matrix composites

By Chen R. Iwabuchi A. Shimizu T. Mifune H. Shin H.S.

Wear, Vol. 213, Iss. 1, 1997-12 ,pp. : 175-184

Elsevier

Access to resources Recommend Favorite

Microstructure Evolution and Mechanical Properties of AZ61 Mg Alloy Processed by Two-Pass Friction Stir Processing

Materials Science Forum, Vol. 2017, Iss. 898, 2017-07 ,pp. : 272-277

Trans Tech Publications

Access to resources Recommend Favorite