An Investigation of Forces and Tool Wear in Milling of Ni₃Al-Base Superalloy

E-ISSN： 1662-9752|2016|861|32-37

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2016, Iss.861, 2016-08, pp. : 32-37

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Effect of Al Content on Microstructure and Creep Behavior of Low Density Ni₃Al-Base Single Crystal Superalloy

Materials Science Forum, Vol. 2015, Iss. 816, 2015-05 ,pp. : 297-303

Trans Tech Publications

Access to resources Recommend Favorite

Optimization of Ta Content of a Third Generation Ni₃Al Base Single Crystal Superalloy

Materials Science Forum, Vol. 2015, Iss. 816, 2015-05 ,pp. : 304-309

Trans Tech Publications

Access to resources Recommend Favorite

Formation of Ni₃Ta, Ni₂Ta and NiTa by High-Energy Ball Milling and Subsequent Heat Treatment

Materials Science Forum, Vol. 2016, Iss. 869, 2016-10 ,pp. : 423-428

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Long-Term Aging on the Evolution of γ' and TCP Phases of a Ni₃Al Based Single Crystal Superalloy

Materials Science Forum, Vol. 2016, Iss. 849, 2016-04 ,pp. : 482-487

Trans Tech Publications

Access to resources Recommend Favorite

A Study on Ultra-Hard AlMgB₁₄ Modified by TiB₂ and Ni₃Al

Materials Science Forum, Vol. 2016, Iss. 848, 2016-04 ,pp. : 607-612

Trans Tech Publications

Access to resources Recommend Favorite