Influence of the Coated Carbide Grade on the Cutting Tool Life When Machining Inconel 718

E-ISSN： 1662-9795|2016|674|271-276

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2016, Iss.674, 2016-02, pp. : 271-276

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Influence of Coolant Application Direction on the Cutting Performance of Ceramic Tool in High-Speed Air-Jet-Assisted Machining of Inconel 718

Key Engineering Materials, Vol. 2017, Iss. 749, 2017-09 ,pp. : 87-93

Trans Tech Publications

Access to resources Recommend Favorite

Tool Wear Characteristics for Near-Dry Cutting of Inconel 718

Key Engineering Materials, Vol. 2014, Iss. 625, 2014-10 ,pp. : 282-287

Trans Tech Publications

Access to resources Recommend Favorite

Aluminum-Based MMC Machining with Carbide Cutting Tool

Key Engineering Materials, Vol. 2016, Iss. 686, 2016-03 ,pp. : 149-154

Trans Tech Publications

Access to resources Recommend Favorite

Self-Sharpening Failure Characteristic of a Si₃N₄ Ceramic Tool in High Speed Cutting of Inconel 718

Key Engineering Materials, Vol. 2016, Iss. 693, 2016-06 ,pp. : 1135-1142

Trans Tech Publications

Access to resources Recommend Favorite

Types of Tool Wear of AlTiN Coated Cutting Insert after Machining of Weld Overlay

Solid State Phenomena, Vol. 2017, Iss. 261, 2017-09 ,pp. : 237-242

Trans Tech Publications

Access to resources Recommend Favorite