Cutting Parameters Optimization Based on Cutting Force Spectrum when Ball Milling A880 Gas Turbine Blade Profiles

E-ISSN： 1662-9752|2016|836|578-583

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2016, Iss.836, 2016-02, pp. : 578-583

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Study on High Speed Milling of Steam Turbine Blade Materials - Difference in Cutting Characteristics by Alloying Elements of Stainless Steel

Materials Science Forum, Vol. 2016, Iss. 874, 2016-11 ,pp. : 439-444

Trans Tech Publications

Access to resources Recommend Favorite

Study on High Speed Milling of Steam Turbine Blade Materials - Differences in Cutting Characteristics of Titanium Alloy and Stainless Steel

Materials Science Forum, Vol. 2016, Iss. 874, 2016-11 ,pp. : 445-449

Trans Tech Publications

Access to resources Recommend Favorite

Simulation of cutting forces in ball-end milling

By Milfelner M. Cus F.

Robotics and Computer-Integrated Manufacturing, Vol. 19, Iss. 1, 2003-02 ,pp. : 99-106

Elsevier

Access to resources Recommend Favorite

Estimation of Machining Error Caused by Deflection of Tool Using Cutting Force in Ball End Milling of Inclined Surface

Materials Science Forum, Vol. 2016, Iss. 874, 2016-11 ,pp. : 525-530

Trans Tech Publications

Access to resources Recommend Favorite

The effects of different hand tool blade coatings on force demands when cutting wood

By Paivinen M. Heinimaa T.

International Journal of Industrial Ergonomics, Vol. 32, Iss. 3, 2003-09 ,pp. : 139-146

Elsevier

Access to resources Recommend Favorite