Mechanical Performance of Polymer-Matrix Laminate Reinforced with 3D Fabric during Three-Point Impact Bending

E-ISSN： 1662-9779|2016|246|193-196

ISSN： 1012-0394

Source： Solid State Phenomena, Vol.2016, Iss.246, 2016-03, pp. : 193-196

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

An experimental investigation on the three-point bending behavior of composite laminate

IOP Conference Series: Materials Science and Engineering, Vol. 62, Iss. 1, 2014-08 ,pp. : 91-98

IOP Publishing

Access to resources Recommend Favorite

Three Point Bending Fatigue of Carbon Fiber Fabric Reinforced Polyphenylensulfide in the Very High Cycle Fatigue Regime

Key Engineering Materials, Vol. 2015, Iss. 664, 2016-01 ,pp. : 47-54

Trans Tech Publications

Access to resources Recommend Favorite

Evaluation of Three-Point Bending Fracture Tests of Selected Concrete: Mechanical Fracture Parameters

Solid State Phenomena, Vol. 2017, Iss. 259, 2017-07 ,pp. : 64-69

Trans Tech Publications

Access to resources Recommend Favorite

Friction and wear characteristics of polymer-matrix friction materials reinforced by brass fibers

By Xian Jia Xiaomei Ling

Journal of Materials Engineering and Performance, Vol. 13, Iss. 5, 2004-10 ,pp. : 642-646

Springer Publishing Company

Access to resources Recommend Favorite

The Impact of Torsion on the Bending Curve during 3D Bending of Thin-Walled Tubes - A Case Study on Forming Helices

Key Engineering Materials, Vol. 2015, Iss. 651, 2015-08 ,pp. : 1595-1601

Trans Tech Publications

Access to resources Recommend Favorite