Tool’s Edges Fragmentation at Gear Hobs – A Method to Reduce Cutting Vibrations

Publisher： Trans Tech Publications

E-ISSN： 1662-7482|2016|835|149-154

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2016, Iss.835, 2016-06, pp. : 149-154

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Application of the Method Based on Knowledge and Experience for Adding the Cutting Tools and Parameters Selection

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 809, 2015-12 ,pp. : 1243-1248

Trans Tech Publications

Access to resources Recommend Favorite

A Promising Method for Improving Wear Resistance of Metal Cutting Tools

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 788, 2015-09 ,pp. : 325-329

Trans Tech Publications

Access to resources Recommend Favorite

Identification of Statistical Properties of Cutting Tool Vibrations in a Continuous Turning Operation—correlation to Structural Properties

By   Håkansson L.   Claesson I.  

Mechanical Systems and Signal Processing, Vol. 11, Iss. 3, 1997-05 ,pp. : 459-489

Academic Press

Access to resources Recommend Favorite

Laser Interferometry Method of Stress Determination in Loaded Cutting Tool Parts

By  

Applied Mechanics and Materials, Vol. 2014, Iss. 698, 2015-01 ,pp. : 537-541

Trans Tech Publications

Access to resources Recommend Favorite

Comparative Evaluation of Efficiency of Metal-Cutting Tool by Method of Pendulum Scribing

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 798, 2015-11 ,pp. : 452-456

Trans Tech Publications

Access to resources Recommend Favorite