Parameters controlling the milling process applied to the productionof AI-Cu-Mg-Si alloys (2214) by mechanical alloying

Publisher： Edp Sciences

E-ISSN： 1286-4897|4|10|1913-1928

ISSN： 1155-4320

Source： Journal de Physique III, Vol.4, Iss.10, 1994-10, pp. : 1913-1928

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Related content

Synthesis of Mg-Cu-Ti based amorphous alloys by mechanical alloying technique

By  

Journal of Physics: Conference Series , Vol. 144, Iss. 1, 2009-01 ,pp. : 79-82

IOP Publishing

Access to resources Recommend Favorite

ANNEALING BEHAVIOUR OF CuTi ALLOYS AT DIFFERENT STAGES OF MECHANICAL ALLOYING

By  

Le Journal de Physique Colloques, Vol. 51, Iss. C4, 1990-07 ,pp. : C4-175-C4-180

Edp Sciences

Access to resources Recommend Favorite

Mechanical properties and microstructure of laser treated Al-Cu-Mg alloys

By  

Le Journal de Physique IV, Vol. 03, Iss. C7, 1993-11 ,pp. : C7-927-C7-932

Edp Sciences

Access to resources Recommend Favorite

Surfactants in Mechanical Alloying/Milling: A Catch-22 Situation

By Nouri Alireza   Wen Cuie  

Critical Reviews in Solid State and Material Sciences, Vol. 39, Iss. 2, 2014-01 ,pp. : 81-108

Taylor & Francis Ltd

Access to resources Recommend Favorite

ON THE AMORPHIZATION OF Fe-Si BY MECHANICAL ALLOYING

By  

Le Journal de Physique Colloques, Vol. 51, Iss. C4, 1990-07 ,pp. : C4-197-C4-203

Edp Sciences

Access to resources Recommend Favorite