Tool wear in high speed machining

E-ISSN： 1764-7177|10|PR9|Pr9-541-Pr9-546

ISSN： 1155-4339

Source： Le Journal de Physique IV, Vol.10, Iss.PR9, 2000-09, pp. : Pr9-541-Pr9-546

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Related content

Experimental Analysis of the Cutting Process and Chip Formation at High Speed Machining

Le Journal de Physique IV, Vol. 07, Iss. C3, 1997-08 ,pp. : C3-33-C3-38

Edp Sciences

Access to resources Recommend Favorite

Tool Wear Prediction in Ti-6Al-4V Machining through Multiple Sensor Monitoring and PCA Features Pattern Recognition

By Caggiano Alessandra

Sensors, Vol. 18, Iss. 3, 2018-03 ,pp. : 823-823

MDPI

Access to resources Recommend Favorite

Experimental observations about the influence of the cuttingconditions in high speed machining of Ti-6Al-4V Titanium alloy

Le Journal de Physique IV, Vol. 134, Iss. issue, 2006-08 ,pp. : 1273-1278

Edp Sciences

Access to resources Recommend Favorite

Bearings for high speed rotors.

Journal de Physique Appliqué, Vol. 22, Iss. S2, 1961-02 ,pp. : 39-42

Edp Sciences

Access to resources Recommend Favorite

High-speed coronal rain

Astronomy & Astrophysics, Vol. 436, Iss. 3, 2005-06 ,pp. : 1067-1074

Edp Sciences

Access to resources Recommend Favorite