Potential of Conformal Cooling Channels in Rapid Heat Cycle Molding: A Review

E-ISSN： 1098-2329|33|1|adv.21381-adv.21381

ISSN： 0730-6679

Source： ADVANCES IN POLYMER TECHNOLOGY, Vol.33, Iss.1, 2014-03, pp. : n/a-n/a

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

β‐Crystal formation in isotactic polypropylene due to rapid heat cycle molding

POLYMERS FOR ADVANCED TECHNOLOGIES, Vol. 26, Iss. 11, 2015-11 ,pp. : 1312-1319

John Wiley & Sons Inc

Access to resources Recommend Favorite

Design and Optimization of Conformal Cooling System of an Injection Molding Chimney

Materials Science Forum, Vol. 2016, Iss. 850, 2016-04 ,pp. : 679-686

Trans Tech Publications

Access to resources Recommend Favorite

Numerical Study on the Combined Heat and Mass Recovery Adsorption Cooling Cycle

ENERGY TECHNOLOGY (ELECTRONIC), Vol. 6, Iss. 2, 2018-02 ,pp. : 296-305

John Wiley & Sons Inc

Access to resources Recommend Favorite

Reliability Evaluation of SiC Power Device Package Used Heat-Resistant Molding Plastic by Power Cycle Test

Materials Science Forum, Vol. 2016, Iss. 858, 2016-06 ,pp. : 1049-1052

Trans Tech Publications

Access to resources Recommend Favorite

Investigation on phosphorus halogen‐free flame‐retardancy systems in short glass fiber‐reinforced PC/ABS composites under rapid thermal cycle molding process condition

POLYMER COMPOSITES, Vol. 36, Iss. 9, 2015-09 ,pp. : 1653-1663

John Wiley & Sons Inc

Access to resources Recommend Favorite