Development of an A356 die casting setup for determining the heat transfer coefficient depending on cooling conditions, gap size, and contact pressure

Publisher： John Wiley & Sons Inc

E-ISSN： 1521-4052|48|12|1235-1240

ISSN： 0933-5137

Source： MATERIALWISSENSCHAFT UND WERKSTOFFTECHNIK, Vol.48, Iss.12, 2017-12, pp. : 1235-1240

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Determination and verification of the gap dependent heat transfer coefficient during permanent mold casting of A356 aluminum alloy

By  

MATERIALWISSENSCHAFT UND WERKSTOFFTECHNIK, Vol. 48, Iss. 12, 2017-12 ,pp. : 1249-1256

John Wiley & Sons Inc

Access to resources Recommend Favorite

The Effect of Air Gap between Casting and Water-Cooled Mold on Interface Heat Transfer Coefficient

By  

Materials Science Forum, Vol. 2017, Iss. 893, 2017-05 ,pp. : 174-180

Trans Tech Publications

Access to resources Recommend Favorite

Numerical Simulations of Low Pressure Die-Casting for A356 Aluminum Rims

By  

Materials Science Forum, Vol. 2017, Iss. 893, 2017-05 ,pp. : 276-280

Trans Tech Publications

Access to resources Recommend Favorite

The Effects of Interfacial Heat Transfer Coefficient on the Microstructure of High-Pressure Die-Cast Magnesium Alloy AM60B

By  

Materials Science Forum, Vol. 2016, Iss. 879, 2017-02 ,pp. : 1755-1759

Trans Tech Publications

Access to resources Recommend Favorite

Measurements of the convection heat transfer coefficient for a planar wall jet: uniform temperature and uniform heat flux boundary conditions

By AbdulNour R.S.   Willenborg K.   McGrath J.J.   Foss J.F.   AbdulNour B.S.  

Experimental Thermal and Fluid Science, Vol. 22, Iss. 3, 2000-09 ,pp. : 123-131

Elsevier

Access to resources Recommend Favorite