The use of modeling to develop a method for the roller drawing of tubes on a long mandrel

ISSN： 0026-0894

Source： Metallurgist, Vol.56, Iss.1-2, 2012-05, pp. : 109-114

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Description of a Mathematical Model of Deformability for the Process of Drawing Tubes on a Fixed Mandrel

By Pospiech J.

Journal of Materials Engineering and Performance, Vol. 7, Iss. 1, 1998-02 ,pp. : 71-78

Springer Publishing Company

Access to resources Recommend Favorite

Formability Discussion in Dieless Drawing of Stainless Steel Tubes

Key Engineering Materials, Vol. 2014, Iss. 626, 2015-01 ,pp. : 10-15

Trans Tech Publications

Access to resources Recommend Favorite

Using the finite-elements method to optimize the compression and spreading of a tubular semifinished product without a mandrel

By Bogatov A. Vitkin D.

Metallurgist, Vol. 54, Iss. 9-10, 2011-01 ,pp. : 699-701

Springer Publishing Company

Access to resources Recommend Favorite

The Influence of the Components of the Bimetallic Tubes for the Way of Deforming in the Hollow Drawing Process

Solid State Phenomena, Vol. 2016, Iss. 246, 2016-03 ,pp. : 225-230

Trans Tech Publications

Access to resources Recommend Favorite

Influence of Die Geometry on Drawing Force in Cold Drawing of Steel Tubes Using Numerical Simulation

Key Engineering Materials, Vol. 2016, Iss. 716, 2016-11 ,pp. : 708-712

Trans Tech Publications

Access to resources Recommend Favorite