Numerical investigation of the real and ideal gap profiles in the calculation of the pressure distortion coefficient and piston fall rate of an LNE 200 MPa pressure balance

Author： Wongthep P.   Rabault T.   Noguera R.   Sarraf C.  

Publisher： IOP Publishing

ISSN： 0026-1394

Source： Metrologia, Vol.50, Iss.2, 2013-04, pp. : 180-186

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Finite element analysis of pressure distortion coefficient and piston fall rate in a simple pressure balance

By Buonanno G.   Dell'Isola M.   Maghenzani R.  

Metrologia, Vol. 36, Iss. 6, 1999-12 ,pp. : 579-584

IOP Publishing

Access to resources Recommend Favorite

New BNM-LNE standard for absolute pressure measurements up to 1 MPa

By Le Guinio J.   Legras J. C.   El-Tawil A.  

Metrologia, Vol. 36, Iss. 6, 1999-12 ,pp. : 535-539

IOP Publishing

Access to resources Recommend Favorite

Piston-cylinder assemblies of 5 cm2 cross-sectional area used in an oil-operated primary pressure balance standard for the 10 MPa range

By Jager J.   Sabuga W.   Wassmann D.  

Metrologia, Vol. 36, Iss. 6, 1999-12 ,pp. : 541-544

IOP Publishing

Access to resources Recommend Favorite

Establishment of traceability of the UME piston-cylinder for the 0.5 GPa range of hydraulic pressure, in cooperation with the BNM-LNE and the PTB

By Orhan M. H.   Legras J. C.   Jager J.  

Metrologia, Vol. 36, Iss. 6, 1999-12 ,pp. : 693-696

IOP Publishing

Access to resources Recommend Favorite

Comparison of methods for calculating distortion in pressure balances up to 400 MPa - EUROMET Project #256

By Molinar G.   Sabuga W.   Robinson G.   Legras J. C.  

Metrologia, Vol. 35, Iss. 5, 1998-10 ,pp. : 739-759

IOP Publishing

Access to resources Recommend Favorite