Machinability of hardened steel using alumina based ceramic cutting tools

Author： Senthil Kumar A.   Raja Durai A.   Sornakumar T.  

Publisher： Elsevier

ISSN： 0263-4368

Source： International Journal of Refractory and Hard Metals, Vol.21, Iss.3, 2003-03, pp. : 109-117

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Related content

Wear Mechanisms of Ceramic Cutting Tool when Cutting Hardened Steel Rolls

By  

Key Engineering Materials, Vol. 2016, Iss. 703, 2016-09 ,pp. : 44-48

Trans Tech Publications

Access to resources Recommend Favorite

The damage of the cutting tools out of carbide metallic during the turning of a soaked and not hardened steel XC38

By  

IOP Conference Series: Materials Science and Engineering, Vol. 28, Iss. 1, 2012-02 ,pp. : 211-220

IOP Publishing

Access to resources Recommend Favorite

Experimental Study on Micro-Machinability of Hardened Tool Steel in Profile Micro-Milling

By  

Solid State Phenomena, Vol. 2017, Iss. 261, 2017-09 ,pp. : 85-92

Trans Tech Publications

Access to resources Recommend Favorite

Performance characteristics of ceria toughened alumina ceramic cutting tool on machining C30 steel

By Senthil Kumar A.   Raja Durai A.   Sornakumar T.  

Powder Metallurgy, Vol. 47, Iss. 3, 2004-09 ,pp. : 235-238

Maney Publishing

Access to resources Recommend Favorite

Flank wears Simulation by using back propagation neural network when cutting hardened H-13 steel in CNC End Milling

By  

IOP Conference Series: Materials Science and Engineering, Vol. 53, Iss. 1, 2013-12 ,pp. : 708-715

IOP Publishing

Access to resources Recommend Favorite