Investigation of the effects of tool micro-geometry and coating on tool temperature during orthogonal turning of quenched and tempered steel

Author： M'Saoubi R.   Chandrasekaran H.  

Publisher： Elsevier

ISSN： 0890-6955

Source： International Journal of Machine Tools and Manufacture, Vol.44, Iss.2, 2004-02, pp. : 213-224

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Related content

Determining the Effect of Process Control Parameters on Tool - Chip Interface Temperature during Hard Turning of AISI D3 Tool Steel in Dry Condition

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 813, 2015-12 ,pp. : 293-298

Trans Tech Publications

Access to resources Recommend Favorite

Nonlinear Analysis of Temperature during Orthogonal Turning

By  

Applied Mechanics and Materials, Vol. 2018, Iss. 880, 2018-05 ,pp. : 309-314

Trans Tech Publications

Access to resources Recommend Favorite

EXPERIMENTAL INVESTIGATION AND PERFORMANCE ANALYSES OF CBN INSERT IN HARD TURNING OF COLD WORK TOOL STEEL (D3)

By Bouchelaghem H.  

Machining Science and Technology, Vol. 14, Iss. 4, 2010-10 ,pp. : 471-501

Taylor & Francis Ltd

Access to resources Recommend Favorite

Cutting Temperature and Tool Wear Assessment of Turning Process with Minimal Quantity Lubrication

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 761, 2015-06 ,pp. : 313-317

Trans Tech Publications

Access to resources Recommend Favorite

Experimental and Numerical Study of the Cutting Temperature during the Turning of the C45 Steel

By  

Applied Mechanics and Materials, Vol. 2016, Iss. 823, 2016-02 ,pp. : 507-512

Trans Tech Publications

Access to resources Recommend Favorite