Thixocasting of hypereutectic Al-25Si-2.5Cu-1Mg-0.5Mn alloys using densified powder compacts

Author： Chen C.M.   Yang C.C.   Chao C.G.  

Publisher： Elsevier

ISSN： 0921-5093

Source： Materials Science and Engineering: A, Vol.366, Iss.1, 2004-02, pp. : 183-194

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Related content

Wear behaviour of eutectic and hypereutectic Al-Si-Cu-Mg casting alloys tested against a composite brake pad

By Lasa L.   Rodriguez-Ibabe J.M.  

Materials Science and Engineering: A, Vol. 363, Iss. 1, 2003-12 ,pp. : 193-202

Elsevier

Access to resources Recommend Favorite

Influence of melt treatments on sliding wear behavior of Al–7Si and Al–7Si–2.5Cu cast alloys

By Basavakumar K.   Mukunda P.   Chakraborty M.  

Journal of Materials Science, Vol. 42, Iss. 18, 2007-09 ,pp. : 7882-7893

Springer Publishing Company

Access to resources Recommend Favorite

Study on the Microstructure and Storage Heat Performance of Mg-25Al-15Zn-xCu Alloys

By  

Advanced Materials Research, Vol. 2015, Iss. 1120, 2015-08 ,pp. : 1104-1108

Trans Tech Publications

Access to resources Recommend Favorite

Reduction of Cavitation Erosion of the Bronze CuAl10Ni5Fe2.5Mn1 by Laser Remelting Treatment

By  

Advanced Materials Research, Vol. 2015, Iss. 1111, 2015-08 ,pp. : 133-138

Trans Tech Publications

Access to resources Recommend Favorite

Decomposition of supersaturated solid solutions in Al–Cu–Mg–Si alloys

By Eskin D.G.  

Journal of Materials Science, Vol. 38, Iss. 2, 2003-01 ,pp. : 279-290

Springer Publishing Company

Access to resources Recommend Favorite