Heating of polymers during neck propagation

ISSN： 0965-545X

Source： Polymer Science, Vol.55, Iss.6, 2013-06, pp. : 404-414

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

The heating of polyethylene terephthalate, polyamide-66, and polyamide-6 during tensile drawing at room temperature was studied theoretically and experimentally. At a low draw rate, the necking temperature was close to the temperature of the surrounding air. An increase in the rate results in the transition to the adiabatic conditions of drawing. A necking temperature of 140°C was experimentally recorded in polyethylene terephthalate at a draw rate of 1000 mm/min and during the approach to the adiabatic conditions of drawing. A formula describing the dependence of the necking temperature on the draw rate was derived. The resulting value agreed fairly well with the theoretical estimation of the temperature. The drawing (strain) ratio in the neck and the draw stress are the crucial parameters determining the temperature. The rate of the transition to the adiabatic conditions of drawing was determined. The temperatures of adiabatic heating for various polymers were calculated. The increases in the temperatures of polycarbonate and low- and high-density polyethylene are relatively low. The increases in temperature can be regarded as moderate for polypropylene and polyvinyl chloride, while they attain the highest values in polyamide-6 and polyethylene terephthalate owing to the high draw ratios in the neck and the high draw-stress values.