Fabrication of In Situ TiBCSi Composite by Hot-Press Sintering

ISSN： 1059-9495

Source： Journal of Materials Engineering and Performance, Vol.22, Iss.3, 2013-03, pp. : 651-654

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Al-Al3Ti nanocomposite produced in situ by two-step hot-press sintering

IOP Conference Series: Materials Science and Engineering, Vol. 40, Iss. 1, 2012-09 ,pp. : 35-45

IOP Publishing

Access to resources Recommend Favorite

Hot-Press Sintering of the W-40wt.%Cu Composite Tape-Casting Film

Key Engineering Materials, Vol. 2017, Iss. 727, 2017-03 ,pp. : 966-971

Trans Tech Publications

Access to resources Recommend Favorite

Preparation of B₄C-ZrB₂ Laminated Composites by Non-Aqueous Tape Casting and Hot-Press Sintering

Key Engineering Materials, Vol. 2016, Iss. 697, 2016-08 ,pp. : 494-497

Trans Tech Publications

Access to resources Recommend Favorite

Creep behavior of TiBw/Ti In-situ composite fabricated by reactive hot pressing

By Ma Z. Tjong S. Li S.

Metallurgical and Materials Transactions A, Vol. 32, Iss. 4, 2001-04 ,pp. : 1019-1022

Springer Publishing Company

Access to resources Recommend Favorite

Sintering of Ti₃SiC₂ Ceramics by Hot Press from Commercial Powders

Key Engineering Materials, Vol. 2015, Iss. 655, 2015-08 ,pp. : 68-71

Trans Tech Publications

Access to resources Recommend Favorite