Estimate of the allowable dimensions of diagnosed defects in category III and IV welded pipeline joints 1

ISSN： 1570-145X

Source： Power Technology and Engineering, Vol.46, Iss.5, 2013-01, pp. : 394-398

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Heat Insulators for Heat Treatment of Welded Joints in Power Equipment

By Parshin S. G.

Power Technology and Engineering, Vol. 38, Iss. 4, 2004-07 ,pp. : 226-229

Springer Publishing Company

Access to resources Recommend Favorite

Failure of Welded Joints in Live Steam and Reheat Lines at 500 MW Power Units

By Gofman Y.M. Simanovskaya E.Y.

Hydrotechnical Construction, Vol. 36, Iss. 4, 2002-07 ,pp. : 205-206

Springer Publishing Company

Access to resources Recommend Favorite

Limiting allowable current loads on the conductors of active high-voltage lines with allowance for their heating by solar radiation

By Nikiforov E.

Power Technology and Engineering, Vol. 40, Iss. 5, 2006-09 ,pp. : 320-323

Springer Publishing Company

Access to resources Recommend Favorite

Calculating the Liquid Flow From a Hole in a Pressurized Pipeline

By Girgidov A.D.

Hydrotechnical Construction, Vol. 35, Iss. 7, 2001-07 ,pp. : 348-352

Springer Publishing Company

Access to resources Recommend Favorite

Atlas of defects and faults of turbogenerators

By Samorodov Yu.

Power Technology and Engineering, Vol. 39, Iss. 1, 2005-01 ,pp. : 60-65

Springer Publishing Company

Access to resources Recommend Favorite