Predicting stereolithography injection mould tool behaviour using models to predict ejection force and tool strength

ISSN： 0020-7543

Source： International Journal of Production Research, Vol.38, Iss.16, 2000-11, pp. : 3747-3757

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Effect of tool finishing on ejection forces for injection moulded parts made using direct metal laser sintered tools

By Majewski C. Hopkinson N.

International Journal of Production Research, Vol. 41, Iss. 3, 2003-01 ,pp. : 581-592

Taylor & Francis Ltd

Access to resources Recommend Favorite

Layer thickness and draft angle selection for stereolithography injection mould tooling

By Harris R. Hopkinson N. Newlyn H. Hague R. Dickens P.

International Journal of Production Research, Vol. 40, Iss. 3, 2002-02 ,pp. : 719-729

Taylor & Francis Ltd

Access to resources Recommend Favorite

Thermal conditions in stereolithography injection mould tooling and their use for polyether-ether-ketone moulding

By Harris R.A. Hague R.J.M. Dickens P.M.

International Journal of Production Research, Vol. 42, Iss. 1, 2004-01 ,pp. : 119-129

Taylor & Francis Ltd

Access to resources Recommend Favorite

Mental models as a practical tool in the engineer's toolbox

By Sinreich David Gopher Daniel Ben-Barak Shay Marmor Yariv Lahat Rakefet

International Journal of Production Research, Vol. 43, Iss. 14, 2005-07 ,pp. : 2977-2996

Taylor & Francis Ltd

Access to resources Recommend Favorite

Tool condition monitoring in milling using vibration analysis

By Yesilyurt I.

International Journal of Production Research, Vol. 45, Iss. 4, 2007-02 ,pp. : 1013-1028

Taylor & Francis Ltd

Access to resources Recommend Favorite