Isophote-based ruled surface approximation of free-form surfaces and its application in NC machining

Author： Han Z.   Yang D. C. H.   Chuang J-J.  

Publisher： Taylor & Francis Ltd

ISSN： 0020-7543

Source： International Journal of Production Research, Vol.39, Iss.9, 2001-06, pp. : 1911-1930

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Tool-path generation for five-axis machining of free-form surfaces based on accessibility analysis

By Xu X.J.   Bradley C.   Zhang Y.F.   Loh H.T.   Wong Y.S.  

International Journal of Production Research, Vol. 40, Iss. 14, 2002-09 ,pp. : 3253-3274

Taylor & Francis Ltd

Access to resources Recommend Favorite

Three dimensional biarc approximation of freeform surfaces for machining tool path generation

By Tseng Y-J.   Chen Y-D.  

International Journal of Production Research, Vol. 38, Iss. 4, 2000-03 ,pp. : 739-763

Taylor & Francis Ltd

Access to resources Recommend Favorite

Tool path re-planning in free-form surface machining for compensation of process-related errors

By Lasemi Ali   Xue Deyi   Gu Peihua  

International Journal of Production Research, Vol. 52, Iss. 20, 2014-10 ,pp. : 5913-5931

Taylor & Francis Ltd

Access to resources Recommend Favorite

Machining of free-form solids using an octree volume decomposition approach

By Tseng Y.-J.   Sue Y.-R.  

International Journal of Production Research, Vol. 37, Iss. 1, 1999-01 ,pp. : 49-72

Taylor & Francis Ltd

Access to resources Recommend Favorite

Five-axis NC milling of ruled surfaces: optimal geometry of a conical tool

By Monies F.   Felices J. N.   Rubio W.   Redonnet J.-M.   Lagarrigue P.  

International Journal of Production Research, Vol. 40, Iss. 12, 2002-08 ,pp. : 2901-2922

Taylor & Francis Ltd

Access to resources Recommend Favorite