An intelligent feature-based process planning system for prismatic parts

ISSN： 0020-7543

Source： International Journal of Production Research, Vol.40, Iss.17, 2002-11, pp. : 4431-4447

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Analysis on multiple sets of feature-based tool paths for prismatic machining parts

By Tseng Y.-J. Lin C.-C.

International Journal of Production Research, Vol. 36, Iss. 12, 1998-12 ,pp. : 3491-3509

Taylor & Francis Ltd

Access to resources Recommend Favorite

Automated setup selection in feature-based process planning

By Wu H.-C. Chang T.-C.

International Journal of Production Research, Vol. 36, Iss. 3, 1998-03 ,pp. : 695-712

Taylor & Francis Ltd

Access to resources Recommend Favorite

Geometry-based machining precedence reasoning for feature-based process planning

By Kim Y.S. Wang E. Rho H.M.

International Journal of Production Research, Vol. 39, Iss. 10, 2001-07 ,pp. : 2077-2103

Taylor & Francis Ltd

Access to resources Recommend Favorite

An intelligent process planning system for micro turn-mill parts

By Leo Kumar S.P. Jerald J. Kumanan S.

International Journal of Production Research, Vol. 52, Iss. 20, 2014-10 ,pp. : 6052-6075

Taylor & Francis Ltd

Access to resources Recommend Favorite

Feature-based representation for manufacturing planning

By Case K. Harun W.A.W.

International Journal of Production Research, Vol. 38, Iss. 17, 2000-11 ,pp. : 4285-4300

Taylor & Francis Ltd

Access to resources Recommend Favorite