Sequential optimization of parameter and tolerance design for multiple dynamic quality characteristics

ISSN： 0020-7543

Source： International Journal of Production Research, Vol.45, Iss.13, 2007-07, pp. : 2939-2954

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Combined parameter and tolerance design optimization with quality and cost

By Jeang A.

International Journal of Production Research, Vol. 39, Iss. 5, 2001-03 ,pp. : 923-952

Taylor & Francis Ltd

Access to resources Recommend Favorite

Joint optimization in process target and tolerance limit for L -type quality characteristics

By Hong Sung Hoon

International Journal of Production Research, Vol. 44, Iss. 15, 2006-08 ,pp. : 3051-3060

Taylor & Francis Ltd

Access to resources Recommend Favorite

Tolerance chart optimization for quality and cost

By Jeang A.

International Journal of Production Research, Vol. 36, Iss. 11, 1998-11 ,pp. : 2969-2983

Taylor & Francis Ltd

Access to resources Recommend Favorite

An integrated approach to tolerance synthesis, process selection and machining parameter optimization problems

By Wang P.

International Journal of Production Research, Vol. 43, Iss. 11, 2005-06 ,pp. : 2237-2262

Taylor & Francis Ltd

Access to resources Recommend Favorite

An integrated joint optimization procedure for robust and tolerance design

By Cho B.-R. Kim Y. J. Kimbler D. L. Phillips M. D.

International Journal of Production Research, Vol. 38, Iss. 10, 2000-07 ,pp. : 2309-2325

Taylor & Francis Ltd

Access to resources Recommend Favorite