On a novel approach to planning cylindrical cutter location for flank milling of ruled surfaces

ISSN： 0020-7543

Source： International Journal of Production Research, Vol.47, Iss.12, 2009-01, pp. : 3289-3305

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Efficient tool path planning for 5-axis flank milling of ruled surfaces using ant colony system algorithms

By Chu Chih-Hsing

International Journal of Production Research, Vol. 49, Iss. 6, 2011-03 ,pp. : 1557-1574

Taylor & Francis Ltd

Access to resources Recommend Favorite

Tool path optimisation for flank milling ruled surface based on the distance function

By Zhang Xiao-Ming Zhu Li-Min Zheng Gang Ding Han

International Journal of Production Research, Vol. 48, Iss. 14, 2010-01 ,pp. : 4233-4251

Taylor & Francis Ltd

Access to resources Recommend Favorite

Five-axis NC milling of ruled surfaces: optimal geometry of a conical tool

By Monies F. Felices J. N. Rubio W. Redonnet J.-M. Lagarrigue P.

International Journal of Production Research, Vol. 40, Iss. 12, 2002-08 ,pp. : 2901-2922

Taylor & Francis Ltd

Access to resources Recommend Favorite

Cutter selection for 5-axis milling of sculptured surfaces based on accessibility analysis

By Li L. L. Zhang Y. F.

International Journal of Production Research, Vol. 44, Iss. 16, 2006-08 ,pp. : 3303-3323

Taylor & Francis Ltd

Access to resources Recommend Favorite

Cutter size optimisation and interference-free tool path generation for five-axis flank milling of centrifugal impellers

By Zheng Gang Zhu Limin Bi Qingzhen

International Journal of Production Research, Vol. 50, Iss. 23, 2012-12 ,pp. : 6667-6678

Taylor & Francis Ltd

Access to resources Recommend Favorite