Effect of wire electrical discharge machining parameters on surface roughness and volumetric material removal rate of tool steels

By Ramazi H.   Nehzat N.  

Ironmaking & Steelmaking, Vol. 36, Iss. 6, 2009-08 ,pp. : 451-455

Maney Publishing

Access to resources Recommend Favorite

Experimental investigations into electrical discharge deep hole drilling of Inconel 718 using copper-tungsten electrode

By Kuppan P.  

International Journal of Mechatronics and Manufacturing Systems, Vol. 5, Iss. 5-6, 2012-10 ,pp. : 399-418

Inderscience Publishers

Access to resources Recommend Favorite

Development of an inversion model for establishing EDM input parameters to satisfy material removal rate, electrode wear ratio and surface roughness

By Sánchez Horacio  

The International Journal of Advanced Manufacturing Technology, Vol. 57, Iss. 1-4, 2011-11 ,pp. : 189-201

Springer Publishing Company

Access to resources Recommend Favorite

Development of semi empirical model for predicting material removal rate during orbital electro discharge machining of Inconel 718

By Dave Harshit K.   Desai Keyur P.   Raval Harit K.  

International Journal of Machining and Machinability of Materials, Vol. 13, Iss. 2-3, 2013-04 ,pp. : 215-230

Inderscience Publishers

Access to resources Recommend Favorite

Effects of Process Parameters on Material Removal Rate and Surface Roughness in Wedm of H-13 Die Tool Steel

By  

Advanced Engineering Forum, Vol. 2018, Iss. 28, 2018-08 ,pp. : 55-66

Trans Tech Publications

Access to resources Recommend Favorite