Intermediate Reynolds/Peclet number, flat plate boundary layer flows over catalytic surfaces for micro-combustion applications

Author: Smyth Suzanne A.  

Publisher: Inderscience Publishers

ISSN: 1471-0234

Source: International Journal of Alternative Propulsion, Vol.1, Iss.2-3, 2007-04, pp. : 294-308

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

The reactive, flat plate boundary layer flow of close-tostoichiometric, methane air mixtures over small size Pt plates is studied experimentally for intermediate Reynolds and Peclet numbers which pertain to micro-combustion applications. The surface temperature was measured with infrared thermography and correlated to reactant concentration profiles acquired with line-Raman imaging. Three phases of combustion were observed. Immediately after the leading edge, a first phase was established with a high surface temperature (>1200°C) and intense fuel depletion. The Reynolds number and equivalence ratio strongly influenced this first phase. It was followed by a second, longer phase, where temperature reached an intermediate value near 1000°C that exhibited little sensitivity to Reynolds number and equivalence ratio. In a third phase, combustion was completed and the surface temperature was reduced to the free-stream mixture temperature. It is suggested that this 'Phase I' combustion can be used for burner miniaturisation through boundary layer interruption.