Optimisation and tool life study in drilling of titanium (Ti-6Al-4V) alloy

Author： Prabukarthi Arumugam  

Publisher： Inderscience Publishers

ISSN： 1748-5711

Source： International Journal of Machining and Machinability of Materials, Vol.13, Iss.2-3, 2013-04, pp. : 138-157

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Oxidation behaviour of Ti6Al4V titanium alloy in oxygen

By Mungole M. N.   Singh N.   Mathur G. N.  

Materials Science and Technology, Vol. 18, Iss. 1, 2002-01 ,pp. : 111-114

Maney Publishing

Access to resources Recommend Favorite

Evaluation of tool wear mechanism of TiAlN coated tools when drilling Ti-6Al-4V

By Rahim Erween A.   Sharif Safian  

International Journal of Manufacturing Technology and Management, Vol. 17, Iss. 4, 2009-03 ,pp. : 327-336

Inderscience Publishers

Access to resources Recommend Favorite

Modelling and optimisation of hole drilling electrical discharge micromachining process of Ti-6Al-4V thin sheet

By Porwal Rajesh Kumar  

International Journal of Precision Technology, Vol. 3, Iss. 2, 2013-04 ,pp. : 183-205

Inderscience Publishers

Access to resources Recommend Favorite

PLASMA HEAT TREATMENT OF TITANIUM AND TITANIUM ALLOY Ti-6Al-4V: EFFECT OF GAS COMPOSITION AND TEMPERATURE

By Rie K. -T.   Lampe Th.   Eisenberg St.  

Surface Engineering, Vol. 1, Iss. 3, 1985-01 ,pp. : 198-202

Maney Publishing

Access to resources Recommend Favorite

Thermally-assisted end milling of titanium alloy Ti-6Al-4V using induction heating

By Ginta Turnad Lenggo  

International Journal of Machining and Machinability of Materials, Vol. 14, Iss. 2, 2013-08 ,pp. : 194-212

Inderscience Publishers

Access to resources Recommend Favorite