Mapping the material removal behaviour of micro deep hole drilling EDM process

ISSN： 1753-1039

Source： International Journal of Mechatronics and Manufacturing Systems, Vol.5, Iss.5-6, 2012-10, pp. : 516-527

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Effect of flushing condition on deep hole micro-EDM drilling

By Meena Vijay Kumar Azad Man Singh Mitra Souren

International Journal of Machining and Machinability of Materials, Vol. 12, Iss. 4, 2012-11 ,pp. : 308-320

Inderscience Publishers

Access to resources Recommend Favorite

Influence of EDM process parameters in deep hole drilling of Inconel 718

By Kuppan P. Rajadurai A. Narayanan S.

The International Journal of Advanced Manufacturing Technology, Vol. 38, Iss. 1-2, 2008-07 ,pp. : 74-84

Springer Publishing Company

Access to resources Recommend Favorite

Calibration of residual stress measurements obtained from EDM hole drilling method using physical material properties

By Lee H. T. Liu C.

Materials Science and Technology, Vol. 24, Iss. 12, 2008-12 ,pp. : 1462-1469

Maney Publishing

Access to resources Recommend Favorite

Determining optimum EDM parameters in drilling a small hole by Taguchi method

By Yusoff Ahmad Razlan Ghazalli Zakri Hussain Hazami Che

International Journal of Manufacturing Technology and Management, Vol. 17, Iss. 4, 2009-03 ,pp. : 345-352

Inderscience Publishers

Access to resources Recommend Favorite

Feasibility evaluation of EDM hole drilling method for residual stress measurement

By Lee H. T. Hsu F. C.

Materials Science and Technology, Vol. 19, Iss. 9, 2003-09 ,pp. : 1261-1265

Maney Publishing

Access to resources Recommend Favorite